How it works

Added capacity only helps if you keep control of your parts. Every job runs through the same four steps.

You send the drawing, quantity, and edge or finish requirement. We confirm the scope, what comes back, and when, before any parts move.

Parts are counted on arrival, logged against your traveler or lot number, and kept segregated from everything else in the shop.

Deburr and finish to the spec you gave us, with in-process checks so nothing reaches your inspector that shouldn't.

Sorted, labeled, packaged, counted out against the count in, and delivered ready for your next operation.

What it does for your floor

The outcomes we're measured on, in your words, not ours.

Finishing stops being the bottleneck between machining and inspection.

Work in process stops stacking up at the deburr bench waiting for a free pair of hands.

A slipped date gets pulled back without overtime or a hiring cycle.

Inspection, coating, and assembly receive parts ready for them, not parts that need another pass.

One lot is enough to see how the process fits your floor.